Installation Guide:
Installation of your Coverbond-5 Car
Cover is a simple procedure. The installation is all about draping the Coverbond-5 Car Cover over the vehicle but before moving ahead to
install the car cover, it is essential for you to ensure that your
vehicle is neat and tidy. Altogether you should take care of certain
other important details for successful Coverbond-5 Car Cover
installation. These are, namely:
Before installing the Coverbond-5 Car
Cover, first of all, you should ensure that the vehicle is clean and
dust free. If the vehicle is not clean, then clean it properly before
draping the Mosom Plus Car Cover around it. If you mistakenly put the
car cover over a dirty vehicle, then dust particles would get stuck to
your car cover and damage the fabric finish.
Secondly, never drape the Coverbond-5 Car Cover over a wet vehicle at any cost.
While installing the Coverbond-5 Car
Cover, ensure that your Coverbond-5 Car Cover never comes in touch with
the sharp edged/too hot exhaust tips. This precaution is necessary
because as soon as your Coverbond-5 Car Cover touches the sharp
edged/too hot exhaust tips, it melts onto tips.
If your vehicle is equipped with a
fixed –position antenna, you need to induce an opening in the Coverbond-5 Car Cover to cover the antenna patches. Now, for proper
installation of the Coverbond-5 Car Cover over the antenna, remove the
antenna first and position the car cover over the vehicle. Then, figure
out the base of the antenna and induce a small opening in the Mosom
Plus Car Cover at the exact position where the antenna meets the base.
Thereafter, install the antenna and take away the car cover and in the
end, you can effortlessly drape the Coverbond-5 Car Cover over the
antenna patches.
Coverbond-5 Car Cover Installation Process:
To install the Coverbond-5 Car Cover
properly, first of all, place it over the vehicle body and unroll it
gradually. Then cover the mirror pockets before moving on to cover the
front and rear ends of the vehicle if your Coverbond-5 Car Cover is
fitted with mirror pockets. Now, after successfully installing the
mirror pockets, you can easily cover the front and rear bumpers of your
vehicle.
Coverbond-5 Car Cover Lock Kit Installation:
Your Coverbond-5 Car Cover lock kit has
a vinyl-coated cable and it is further equipped with a metal piece on
one end and a loop at the other end. Now, after moving to the
passenger’s side, fix the cable loop at a position of around two inches
through the grommet. Next, take the metal piece end along under the
grommet through the loop of the first cable and take it to the driver’s
side. Thereafter, from the driver’s corner, pull the cable from outside
the cover by two inches through the grommet and then lock the end piece
to the cable body.
Join Us On Twitter
Join Us On Facebook