Triguard Car Cover Installation Process:
For proper installation, place the
Triguard Car Cover over your vehicle first and then unfold it slowly.
If your vehicle cover is fitted with mirror pockets, install the mirror
pockets before installing the car cover over the front and rear ends of
your vehicle. Proper installation of the mirror pockets keeps your
Triguard Car Cover fixed to its position in stormy weather conditions
without letting the car cover to fall off. Now, after installing the
mirror pockets, you can move ahead to install the Triguard Car Cover
over the front and rear end of your vehicle.
Specific Measures To Be Adopted Before And During Installation:
Before installing the Triguard Car
Cover, you are especially required to ensure that the body of your car
is adequately clean and dust free. If your car body is dust ridden, you
are at risk of attracting dust particles to your Triguard Car Cover and
once dust and dirt particles are stuck to your car cover, it is likely
to unleash fabric damage to your car cover. So, clean the body of your
car properly before installing the Triguard Car Cover over it.
Altogether, you should ensure not to install the Triguard Car Cover
over a wet vehicle.
While installing the Triguard Car
Cover, it is necessary for you to keep your car cover away from the
exhaust tips if they are too sharp-edged or hot. Once coming in touch
with hot/sharp edged vehicle tips, your car cover is likely to melt
You are also required to induce a small
opening in your car cover to install it properly over the antenna
positioned on your car. If there is no such antenna over your car, you
are not required to cut a portion of your car cover. However, to
install the Triguard Car Cover successfully over the antenna, you are
required to follow a few steps. First of all, remove the car cover and
fix the antenna at the usual position, Thereafter, select the point
where the base of the antenna meets the car and cut a small opening in
your Triguard Car Cover at this point. After this, you are required to
install the antenna and then position the car cover over the antenna
Triguard Car Cover Lock Kit Installation:
If you have a car cover lock kit, you
should install it properly to prevent theft of your car cover. Your
Triguard Car Cover lock kit has a small vinyl coated cable and this
cable is further equipped with a metal piece on one end and a loop on
the other end.
For the installation of your Triguard
Car Cover lock kit, first of all, move ahead to the passenger’s side
and fix the loop at around two inches through the grommet. After that,
push the metal piece, the other end of the cable to the driver’s side
by first taking it along under the grommet via the loop of the first
cable. Now, reaching for the driver’s side, pull the cable along from
outside the cover by two inches through the grommet and then you can
easily lock the end pieces of the cable.